RG-AP680-CD(V3) Ruijie Wi-Fi 6 2976Mbps Outdoor Access Point, Directional Antennas

Product Specification

Overview

Ruijie RG-AP680-CD(V3)  Industrial-Grade Access Point Wireless Access Point แบบ Outdoor สำหรับติดตั้งภายนอกอาคาร มาตรฐาน WIFI6 ความเร็ว 2.98Gbps, Port Lan Gigabit, Port SFP 2.5Gbps, เสาอากาศกระจายสัญญาณแบบทิศทาง 60 องศา

ทนอุณหถูมิสูงถึง 65 องศา

กันน้ำกันฝุ่นมาตรฐาน IP68

รองรับการ Control แบบ Stanalone, Free Cloud Control, Hardware Controll

พร้อม Ruijie Cloud License แบบ Lifetime

802.11n

Four spatial streams
Radio 1 – 2.4 GHz: 2x2 MU-MIMO, two spatial streams
Radio 2 – 5 GHz: 4x4 MU-MIMO, two spatial streams

Channels:
Radio 1 – 2.4 GHz: 20 MHz and 40 MHz
Radio 2 – 5 GHz: 20 MHz and 40 MHz

Combined peak data rate: 0.6 Gbps
Radio 1 – 2.4 GHz: 6.5 Mbps to 300 Mbps (MCS0 to MCS15 )
Radio 2 – 5 GHz: 6.5 Mbps to 300 Mbps (MCS0 to MCS15)

Radio technologies: Orthogonal Frequency-Division Multiplexing (OFDM)
Modulation types: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM

Packet aggregation:
Aggregate MAC Protocol Data Unit (A-MPDU)
Aggregate MAC Service Data Unit (A-MSDU)
Dynamic Frequency Selection (DFS)
Cyclic Delay/Shift Diversity (CDD/CSD)
Maximum Ratio Combining (MRC)
Space-Time Block Coding (STBC)
Low-Density Parity Check (LDPC)
Transmit beam-forming (TxBF)

802.11ac

Two spatial streams
Radio 2 – 5 GHz: 2x2 MU-MIMO, two spatial streams

Channels:
Radio 2 – 5 GHz: 20 MHz, 40 MHz, 80 MHz, and 160 MHz

Combined peak data rate: 1.732 Gbps
Radio 2 – 5 GHz: 6.5 Mbps to 1.732 Gbps (MCS0 to MCS9)

Radio technologies: Orthogonal Frequency-Division Multiplexing (OFDM)
Modulation types: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM

Packet aggregation:
Aggregate MAC Protocol Data Unit (A-MPDU)
Aggregate MAC Service Data Unit (A-MSDU)
Dynamic Frequency Selection (DFS)
Cyclic Delay/Shift Diversity (CDD/CSD)
Maximum Ratio Combining (MRC)
Space-Time Block Coding (STBC)
Low-Density Parity Check (LDPC)
Transmit beam-forming (TxBF)

802.11ax

Four spatial streams
Radio 1 – 2.4 GHz: 2x2 uplink/downlink MU-MIMO, two spatial streams
Radio 2 – 5 GHz: 2x2 uplink/downlink MU-MIMO, two spatial streams

Channels:
Radio 1 – 2.4 GHz: 20 MHz and 40 MHz
Radio 2 – 5 GHz: 20 MHz, 40 MHz, 80 MHz, and 160 MHz

Combined peak data rate: 2.976 Gbps:
Radio 1 – 2.4 GHz: 8.6 Mbps to 0.574 Gbps (MCS0 to MCS11)
Radio 2 – 5 GHz: 8.6 Mbps to 2.402 Gbps (MCS0 to MCS11)
Radio technologies: uplink/downlink Orthogonal Frequency-Division Multiple Access (OFDMA)
Modulation types: BPSK, QPSK, 16-QAM, 64-QAM, 256-QAM, 1024-QAM

Packet aggregation:
Aggregate MAC Protocol Data Unit (A-MPDU)
Aggregate MAC Service Data Unit (A-MSDU)
Dynamic Frequency Selection (DFS)
Cyclic Delay/Shift Diversity (CDD/CSD)
Maximum Ratio Combining (MRC)
Space-Time Block Coding (STBC)
Low-Density Parity Check (LDPC)
Transmit beam-forming (TxBF)
WPA3

Antenna

Wi-Fi
2.4 GHz: two built-in directional antennas, the max. antenna gain is 9 dBi.
5 GHz: two built-in directional antennas, the max. antenna gain is 9 dBi.

Bluetooth
One integrated vertically polarized omnidirectional antenna, the max. antenna gain is 4.5 dBi.

Port

1 x 2.5GE SFP port
1 x 10/100/1000Base-T RJ45 Ethernet port with auto-negotiation
1 x RJ45 console port (serial console port)
1 x Bluetooth 5.0

Status LED

1 x multi-color system status LED
AP power-on status
Software initialization status and upgrade status
Uplink service interface status
Wireless user online status
CAPWAP tunnel timeout
Specific AP locating
Three single-color signal strength LEDs:
Whether bridging is enabled
Whether bridging is successful
Wireless signal strength after successful bridging

Button

1 x Reset button
Press the button for shorter than 2 seconds. Then the device restarts.
Press the button for longer than 5 seconds. Then the device restores to factory settings.

Dimensions (W x D x H)

Main unit: 251 mm x 168 mm x 64 mm (9.9 in. x 6.6 in. x 2.5 in.)
Shipping: 405 mm x 232 mm x 325 mm (15.9 in. x 9.1 in. x 12.8 in.)

Weight

Main unit: 1.5 kg (3.31 lbs)
Mounting bracket: 0.2 kg (0.44 lbs)
Shipping: 2.92 kg (6.44 lbs)

Mounting

Wall- or pole-mounting (a mounting bracket is delivered with the main unit)

Input power supply

The AP supports the following two power supply modes:
48 V DC/0.35 A power input over DC connector: The DC connector accepts 2.0 mm/6.3 mm center-positive circular plug. A DC power supply needs to be purchased independently.
PoE input over ETH/PoE: The power source equipment (PSE) complies with IEEE 802.3af/at standard (PoE/PoE+).
Note: If both DC power and PoE are available, DC power is preferred.

Power consumption

Maximum power consumption: 12.95 W
DC power: 12.95 W
802.3at (PoE+): 12.95 W
802.3af (PoE): 12.95 W
Idle mode: 6.0 W

Environment

Storage temperature: –40°C to +85°C (–40°F to +185°F)
Storage humidity: 0% RH to 100% RH (non-condensing)
Operating temperature: –40°C to +65°C (-40°F to 149°F)
Operating humidity: 0% RH to 100% RH (non-condensing)
At an altitude between 3,000 m (9,842.52 ft.) and 5,000 m (16,404.20 ft.), every time the altitude increases by 166 m (546 ft.), the maximum temperature decreases by 1°C (1.8°F).

Mean Time Between Failure (MTBF)

200,000 hours (22 years) at the operating temperature of 25°C (77°F)

System memory

512 MB DRAM, 128 MB flash

Transmit power

2.4 GHz
Max. transmit power: 28 dBm (631mW)
Minimum transmit power: 10 dBm (10 mW)

5 GHz
Max. transmit power: 28 dBm (631mW)
Minimum transmit power: 10 dBm (10 mW)
Note: The transmit power adjusted in percentage. The transmit power is limited by local regulatory requirements.

Basic Function

RG-AP680-CD(V3)

Applicable software version

RGOS11.9(6)W2B4 or higher

WLAN

Max. number of associated STAs

1024 (up to 512 STAs per radio)

Max. number of BSSIDs

32 (up to 16 BSSIDs per radio)

Max. number of WLAN IDs

16

STA management

SSID hiding
Band steering
Each SSID can be configured with the authentication mode, encryption mechanism, and VLAN attributes independently.
Remote Intelligent Perception Technology (RIPT)
Intelligent load balancing based on the STA quantity or traffic
Rate set settings
Intelligent STA identification

STA limiting

SSID-based STA limiting
Radio-based STA limiting

Bandwidth limiting

STA/SSID/AP-based rate limiting

CAPWAP

IPv4/IPv6 CAPWAP
Layer 2 and Layer 3 topology between an AP and an AC
An AP can automatically discover the accessible AC.
An AP can be automatically upgraded through the AC.
An AP can automatically download the configuration file from the AC.
CAPWAP through NAT

Data forwarding

Centralized and local forwarding

Wireless roaming

Layer 2 and Layer 3 roaming

Wireless locating

MU and TAG device locating

Security and Authentication

Authentication and encryption

Remote Authentication Dial-In User Service (RADIUS)
EXEC authorization, specifying the source IP address of RADIUS packets, and built-in authentication server
PSK and web authentication
QR code-based guest authentication, SMS authentication, and MAC address bypass (MAB) authentication
Data encryption: WEP (64/128 bits), WPA (TKIP), WPA-PSK, WPA2 (AES), WPA3-Enterprise, WPA3-Individual

Data frame filtering

Allowlist, static blocklist, and dynamic blocklist

WIDS

Wireless Intrusion Detection System(WIDS)
User isolation

ACL

IP standard ACL, MAC extended ACL, IP extended ACL, and expert-level ACL
IPv6 ACL
Time range-based ACL
ACL based on a Layer 2 interface
ACL based on a Layer 3 interface
Ingress ACL based on a wireless interface
Dynamic ACL assignment based on 802.1X authentication (used with the AC)
ACL REMARK

CPP

CPU Protect Policy (CPP)

NFPP

Network Foundation Protection Policy (NFPP)

Routing and Switching

MAC

Static and filtered MAC addresses
MAC address table size: 1,024
Max. number of static MAC addresses: 1,024
Max. number of filtered MAC addresses: 1,024

Ethernet

Jumbo frame length: 1518
Full-duplex and half-duplex modes of interfaces
IEEE802.1p and IEEE802.1Q

VLAN

Interface-based VLAN assignment
Max. number of SVIs: 200
Max. number of VLANs: 4,094
VLAN ID range: 1–4,094

ARP

ARP entry aging, gratuitous ARP learning, and proxy ARP
Max. number of ARP entries: 1,024
ARP check

IPv4 services

Static and DHCP-assigned IPv4 addresses
NAT, FTP ALG and DNS ALG

IPv6 services

IPv6 addressing, Neighbor Discovery (ND), ICMPv6, IPv6 ping
IPv6 DHCP client

IP routing

IPv4/IPv6 static route
Max. number of static IPv4 routes: 1,024
Max. number of static IPv6 routes: 1,000

Multicast

Multicast-to-unicast conversion

VPN

PPPoE client
IPsec VPN

Network Management and Monitoring

Network management

NTP server and NTP client
SNTP client
SNMPv1/v2c/v3
Fault detection and alarm
Information statistics and logging

Network management platform

Web management (Eweb)

User access management

Telnet, SSH, FTP client, FTP management

Switchover among Fat, Fit, and cloud modes

When the AP works in Fit mode, it can be switched to Fat mode through an AC.
When the AP works in Fat mode, it can be switched to Fit mode through the console port or Telnet mode.
When the AP works in cloud mode, it can be managed through Ruijie Cloud.

ประกัน

3 ปี